The first three non-comment configuration lines are as follows:
.code
-domainlist local_domains = @
+domainlist local_domains = @
domainlist relay_to_domains =
hostlist relay_from_hosts = 127.0.0.1
.endd
fact authenticate until you complete the authenticator definitions.
.code
require message = relay not permitted
- domains = +local_domains : +relay_domains
+ domains = +local_domains : +relay_to_domains
.endd
This statement rejects the address if its domain is neither a local domain nor
one of the domains for which this host is a relay.
.endd
In a list, the syntax is similar. For example:
.code
-domainlist relay_domains = sqlite;/some/thing/sqlitedb \
+domainlist relay_to_domains = sqlite;/some/thing/sqlitedb \
select * from relays where ip='$sender_host_address';
.endd
The only character affected by the &%quote_sqlite%& operator is a single
subject having matched any of the patterns, it is in the set if the last item
was a negative one, but not if it was a positive one. For example, the list in
.code
-domainlist relay_domains = !a.b.c : *.b.c
+domainlist relay_to_domains = !a.b.c : *.b.c
.endd
matches any domain ending in &'.b.c'& except for &'a.b.c'&. Domains that match
neither &'a.b.c'& nor &'*.b.c'& do not match, because the last item in the
list is positive. However, if the setting were
.code
-domainlist relay_domains = !a.b.c
+domainlist relay_to_domains = !a.b.c
.endd
then all domains other than &'a.b.c'& would match because the last item in the
list is negative. In other words, a list that ends with a negative item behaves
respectively. Then there follows the name that you are defining, followed by an
equals sign and the list itself. For example:
.code
-hostlist relay_hosts = 192.168.23.0/24 : my.friend.example
+hostlist relay_from_hosts = 192.168.23.0/24 : my.friend.example
addresslist bad_senders = cdb;/etc/badsenders
.endd
A named list may refer to other named lists:
In the main part of the configuration, you put the following definitions:
.code
-domainlist local_domains = my.dom1.example : my.dom2.example
-domainlist relay_domains = friend1.example : friend2.example
-hostlist relay_hosts = 192.168.45.0/24
+domainlist local_domains = my.dom1.example : my.dom2.example
+domainlist relay_to_domains = friend1.example : friend2.example
+hostlist relay_from_hosts = 192.168.45.0/24
.endd
Now you can use these definitions in the ACL that is run for every RCPT
command:
.code
acl_check_rcpt:
- accept domains = +local_domains : +relay_domains
- accept hosts = +relay_hosts
+ accept domains = +local_domains : +relay_to_domains
+ accept hosts = +relay_from_hosts
.endd
The first statement accepts any RCPT command that contains an address in
the local or relay domains. For any other domain, control passes to the second
git://git.exim.org / users / jgh / exim.git / commitdiff