-$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.41 2004/11/25 13:54:31 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.70 2005/01/13 16:15:52 ph10 Exp $
Change log file for Exim from version 4.21
-------------------------------------------
-
-Exim version 4.44
+Exim version 4.50
-----------------
1. Minor wording change to the doc/README.SIEVE file.
just the host names, not the priorities.
(3) It is now possible to give a list of domains (or IP addresses) to be
- looked up.
+ looked up. The behaviour when one of the lookups defers can be
+ controlled by a keyword.
(4) It is now possible to specify the separator character for use when
multiple records are returned.
42. Allow both -bf and -bF in the same test run.
+43. Did the same fix as 41 above for OpenSSL, which had the same infelicity.
+
+44. The "Exiscan patch" is now merged into the mainline Exim source.
+
+45. Sometimes the final signoff response after QUIT could fail to get
+ transmitted in the non-TLS case. Testing !tls_active instead of tls_active
+ < 0 before doing a fflush(). This bug looks as though it goes back to the
+ introduction of TLS in release 3.20, but "sometimes" must have been rare
+ because the tests only now provoked it.
+
+46. Reset the locale to "C" after calling embedded Perl, in case it was changed
+ (this can affect the format of dates).
+
+47. exim_tidydb, when checking for the continued existence of a message for
+ which it has found a message-specific retry record, was not finding
+ messages that were in split spool directories. Consequently, it was
+ deleting retry records that should have stayed in existence.
+
+48. Steve fixed some bugs in eximstats.
+
+49. The SPA authentication driver was not abandoning authentication and moving
+ on to the next authenticator when an expansion was forced to fail,
+ contradicting the general specification for all authenticators. Instead it
+ was generating a temporary error. It now behaves as specified.
+
+50. The default ordering of permitted cipher suites for GnuTLS was pessimal
+ (the order specifies the preference for clients). The order is now AES256,
+ AES128, 3DES, ARCFOUR128.
+
+51. Small patch to Sieve code - explicitly set From: when generating an
+ autoreply.
+
+52. Exim crashed if a remote delivery caused a very long error message to be
+ recorded - for instance if somebody sent an entire SpamAssassin report back
+ as a large number of 550 error lines. This bug was coincidentally fixed by
+ increasing the size of one of Exim's internal buffers (big_buffer) that
+ happened as part of the Exiscan merge. However, to be on the safe side, I
+ have made the code more robust (and fixed the comments that describe what
+ is going on).
+
+53. Now that there can be additional text after "Completed" in log lines (if
+ the queue_time_overall log selector is set), a one-byte patch to exigrep
+ was needed to allow it to recognize "Completed" as not the last thing in
+ the line.
+
+54. The LDAP lookup was not handling a return of LDAP_RES_SEARCH_REFERENCE. A
+ patch that reportedly fixes this has been added. I am not expert enough to
+ create a test for it. This is what the patch creator wrote:
+
+ "I found a little strange behaviour of ldap code when working with
+ Windows 2003 AD Domain, where users was placed in more than one
+ Organization Units. When I tried to give exim partial DN, the exit code
+ of ldap_search was unknown to exim because of LDAP_RES_SEARCH_REFERENCE.
+ But simultaneously result of request was absolutely normal ldap result,
+ so I produce this patch..."
+
+ Later: it seems that not all versions of LDAP support LDAP_RES_SEARCH_
+ REFERENCE, so I have modified the code to exclude the patch when that macro
+ is not defined.
+
+55. Some experimental protocols are using DNS PTR records for new purposes. The
+ keys for these records are domain names, not reversed IP addresses. The
+ dnsdb PTR lookup now tests whether its key is an IP address. If not, it
+ leaves it alone. Component reversal etc. now happens only for IP addresses.
+
+56. Improve error message when ldap_search() fails in OpenLDAP or Solaris LDAP.
+
+57. Double the size of the debug message buffer (to 2048) so that more of very
+ long debug lines gets shown.
+
+58. The exicyclog utility now does better if the number of log files to keep
+ exceeds 99. In this case, it numbers them 001, 002 ... instead of 01, 02...
+
+59. Two changes related to the smtp_active_hostname option:
+
+ (1) $smtp_active_hostname is now available as a variable.
+ (2) The default for smtp_banner uses $smtp_active_hostname instead
+ of $primary_hostname.
+
+60. The host_aton() function is supposed to be passed a string that is known
+ to be a valid IP address. However, in the case of IPv6 addresses, it was
+ not checking this. This is a hostage to fortune. Exim now panics and dies
+ if the condition is not met. A case was found where this could be provoked
+ from a dnsdb PTR lookup with an IPv6 address that had more than 8
+ components; fortuitously, this particular loophole had already been fixed
+ by change 4.50/55 above.
+
+ If there are any other similar loopholes, the new check in host_aton()
+ itself should stop them being exploited. The report I received stated that
+ data on the command line could provoke the exploit when Exim was running as
+ exim, but did not say which command line option was involved. All I could
+ find was the use of -be with a bad dnsdb PTR lookup, and in that case it is
+ running as the user.
+
+61. There was a buffer overflow vulnerability in the SPA authentication code
+ (which came originally from the Samba project). I have added a test to the
+ spa_base64_to_bits() function which I hope fixes it.
+
+62. Configuration update for GNU/Hurd and variations. Updated Makefile-GNU and
+ os.h-GNU, and added configuration files for GNUkFreeBSD and GNUkNetBSD.
+
+63. The daemon start-up calls getloadavg() while still root for those OS that
+ need the first call to be done as root, but it missed one case: when
+ deliver_queue_load_max is set with deliver_drop_privilege. This is
+ necessary for the benefit of the queue runner, because there is no re-exec
+ when deliver_drop_privilege is set.
+
+64. A call to exiwhat cut short delays set up by "delay" modifiers in ACLs.
+ This has been fixed.
+
+65. Caching of lookup data for "hosts =" ACL conditions, when a named host list
+ was in use, was not putting the data itself into the right store pool;
+ consequently, it could be overwritten for a subsequent message in the same
+ SMTP connection. (Fix 4.40/11 dealt with the non-cache case, but overlooked
+ the caching.)
+
+66. Added hosts_max_try_hardlimit to the smtp transport, default 50.
+
+67. The string_is_ip_address() function returns 0, 4, or 6, for "no an IP
+ address", "IPv4 address", and "IPv6 address", respectively. Some calls of
+ the function were treating the return as a boolean value, which happened to
+ work because 0=false and not-0=true, but is not correct code.
+
+68. The host_aton() function was not handling scoped IPv6 addresses (those
+ with, for example, "%eth0" on the end) correctly.
+
+69. Fixed some compiler warnings in acl.c for the bitmaps specified with
+ negated items (that is, ~something) in unsigned ints. Some compilers
+ apparently mutter when there is no cast.
+
+70. If an address verification called from an ACL failed, and did not produce a
+ user-specific message (i.e. there was only a "system" message), nothing was
+ put in $acl_verify_message. In this situation, it now puts the system
+ message there.
+
+71. Change 4.23/11 added synchronization checking at the start of an SMTP
+ session; change 4.31/43 added the unwanted input to the log line - except
+ that it did not do this in the start of session case. It now does.
+
Exim version 4.43
-----------------
git://git.exim.org / users / jgh / exim.git / blobdiff