Make batch delivery work for files and pipes set up by redirection.

[users/jgh/exim.git] / doc / doc-txt / ChangeLog

diff --git a/doc/doc-txt/ChangeLog b/doc/doc-txt/ChangeLog
index 9f8d80b141fa298b97eb292a79b661592bbcec0d..8fb90d75007ccf3680638645231267d23ce6a80a 100644 (file)
--- a/doc/doc-txt/ChangeLog
+++ b/doc/doc-txt/ChangeLog
@@ -1,4 +1,4 @@
-$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.342 2006/04/19 11:15:43 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.344 2006/04/20 14:11:29 ph10 Exp $
 
 Change log file for Exim from version 4.21
 -------------------------------------------
@@ -24,6 +24,15 @@ PH/02 When tcp-wrappers is called from Exim, it returns only "deny" or "allow".
 
 PH/03 Add -lutil to the default FreeBSD LIBS setting.
 
+PH/04 Change PH/19 for 4.61 was too wide. It should not be applied to host
+      errors. Otherwise a message that provokes a temporary error (when other
+      messages do not) can cause a whole host to time out.
+
+PH/05 Batch deliveries by appendfile and pipe transports did not work when the
+      addresses were routed directly to files or pipes from a redirect router.
+      File deliveries just didn't batch; pipe deliveries might have suffered
+      odd errors.
+
 
 Exim version 4.61
 -----------------
@@ -137,6 +146,7 @@ PH/19 When calculating a retry time, Exim used to measure the "time since
       when small messages continue to be delivered. Without this change, the
       "time since failure" will always be short, possible causing more frequent
       delivery attempts for the huge message than are intended.
+      [Note: This change was subsequently modified - see PH/04 for 4.62.]
 
 PH/20 Added $auth1, $auth2, $auth3 to contain authentication data (as well as
       $1, $2, $3) because the numerical variables can be reset during some