Add control=fakedefer to go with control=fakereject.

[users/jgh/exim.git] / doc / doc-txt / NewStuff

diff --git a/doc/doc-txt/NewStuff b/doc/doc-txt/NewStuff
index a4ac7e5adbd43e46bd768e274d879c52094d9bd6..d7bdff1e1f128a0f6dd21ca2308ae832b7612cf0 100644 (file)
--- a/doc/doc-txt/NewStuff
+++ b/doc/doc-txt/NewStuff
@@ -1,4 +1,4 @@
-$Cambridge: exim/doc/doc-txt/NewStuff,v 1.41 2005/05/17 09:53:34 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/NewStuff,v 1.43 2005/05/23 15:28:37 fanf2 Exp $
 
 New Features in Exim
 --------------------
@@ -81,6 +81,22 @@ PH/01 The amount of output produced by the "make" process has been reduced,
       command reflection in "make". When you ask for the full output, it is
       given in addition to the the short output.
 
+PH/02 There have been two changes concerned with submission mode:
+
+      (a) A new option, /name=value, makes it possible to supply a user name
+          to be inserted into any created Sender: header line. Typically, this
+          would be looked up from $authenticated_id.
+
+      (b) The envelope sender address is forced to be the same as the
+          submission mode sender address.
+
+TF/02 The control = fakereject ACL modifier now has a fakedefer counterpart,
+      which works in exactly the same way except it causes a fake SMTP 450
+      response after the message data instead of a fake SMTP 550 response.
+      You must take care when using fakedefer because it will cause messages
+      to be duplicated when the sender retries. Therefore you should not use
+      fakedefer if the message will be delivered normally.
+
 
 Version 4.51
 ------------