+Q0740: How can I change the MAIL FROM address that is used for callouts?
+
+A0740: It depends on which type of callout you are using.
+
+ (1) For envelope sender verification callouts, you cannot make any
+ change. My view is that an envelope sender verification is testing
+ whether Exim could send a bounce to that address. Therefore, it must
+ use \"MAIL FROM:<>"\ because that is what it would do if it were
+ sending a bounce message. If \"MAIL FROM:<>"\ is rejected, it means
+ Exim could not send a bounce. Therefore the callout fails.
+
+ (2) For verifying addresses in the ::From::, ::Sender::, or ::Reply-to::
+ header lines (the \"verify = header_sender"\ condition), it is
+ possible to make a change, on the grounds that these addresses are
+ not necessarily ones that must accept bounce messages. You can do
+ this by adding a \"mailfrom"\ option, like this:
+
+==> require verify = header_sender/callout=mailfrom=abcd@x.y.z
+
+ (3) It is also possible to make a change for the postmaster verification
+ option, also on the grounds that a postmaster address need not
+ accept bounces if it is never used as an envelope sender. Instead of
+ just \"postmaster"\, \"postmaster_mailfrom"\ is used, like this:
+
+==> require verify = sender/callout=postmaster_mailfrom=abcd@x.y.z
+
+ (4) For recipient verification, there are three possibilities. The
+ default is to use \"MAIL FROM:<>"\. If the \use_postmaster\ option
+ is given, for example:
+
+==> require verify = recipient/callout=use_postmaster
+
+ then the address for MAIL FROM is made up from the local part
+ \"postmaster"\ and the contents of \$qualify_domain$\.
+
+ Alternatively, if the \use_sender\ option is given, the sender
+ address of the incoming message is used. You should use this option
+ only when you know that the receiving host makes use of the sender
+ address when verifying. The reason is that the callout cache is much
+ less effective in this case, causing many more callouts to be
+ performed.
+
+ In all cases when you configure Exim to use a non-empty address in MAIL
+ FROM during callout processing, you should think carefully about what
+ might happen if this causes the called host to make its own callout back
+ to your host. Make sure that callout loops cannot happen.
+
+
+Q0741: How can I get Outlook Express to use TLS when authenticating?
+
+A0741: If you check \"auth required"\ in OE, it will authenticate as soon as
+ it sees AUTH LOGIN, in preference to STARTTLS. The trick is to
+ advertise things to OE in a certain order. The first EHLO should
+ advertise STARTTLS but not AUTH, and only the second EHLO (after TLS
+ starts) should advert AUTH. One way of achieving this is to put, in
+ the main section of your Exim configuration:
+
+==> auth_advertise_hosts = ${if eq{$tls_cipher}{}{127.0.0.1}{*}}
+
+ This means that the only host to which AUTH is advertised is 127.0.0.1
+ when the session is not encrypted (that is, before TLS has started). The
+ idea here is that there's no need for encryption for anything coming via
+ the loopback interface. For an encrypted session, however, AUTH is
+ advertised to all hosts.
+
+ You can also block the AUTH command itself for unencrypted connections,
+ by creating an ACL for \acl_smtp_auth\ that is something like this:
+
+==> accept encrypted = *
+ accept hosts = 127.0.0.1
+ deny message = TLS encryption required before AUTH
+
+
git://git.exim.org / users / jgh / exim.git / blobdiff