-$Cambridge: exim/doc/doc-txt/NewStuff,v 1.40 2005/05/10 10:19:11 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/NewStuff,v 1.43 2005/05/23 15:28:37 fanf2 Exp $
New Features in Exim
--------------------
The authorization code can be "Y" for yes, "N" for no, "X" for explicit
authorization required but absent, or "?" for unknown.
+PH/01 The amount of output produced by the "make" process has been reduced,
+ because the compile lines are often rather long, making it all pretty
+ unreadable. The new style is along the lines of the 2.6 Linux kernel:
+ just a short line for each module that is being compiled or linked.
+ However, it is still possible to get the full output, by calling "make"
+ like this:
+
+ FULLECHO='' make -e
+
+ The value of FULLECHO defaults to "@", the flag character that suppresses
+ command reflection in "make". When you ask for the full output, it is
+ given in addition to the the short output.
+
+PH/02 There have been two changes concerned with submission mode:
+
+ (a) A new option, /name=value, makes it possible to supply a user name
+ to be inserted into any created Sender: header line. Typically, this
+ would be looked up from $authenticated_id.
+
+ (b) The envelope sender address is forced to be the same as the
+ submission mode sender address.
+
+TF/02 The control = fakereject ACL modifier now has a fakedefer counterpart,
+ which works in exactly the same way except it causes a fake SMTP 450
+ response after the message data instead of a fake SMTP 550 response.
+ You must take care when using fakedefer because it will cause messages
+ to be duplicated when the sender retries. Therefore you should not use
+ fakedefer if the message will be delivered normally.
+
Version 4.51
------------
git://git.exim.org / users / heiko / exim.git / blobdiff