+Exim version 4.51
+-----------------
+
+TK/01 Added Yahoo DomainKeys support via libdomainkeys. See
+ doc/experimental-spec.txt for details. (http://domainkeys.sf.net)
+
+TK/02 Fix ACL "control" statement not being available in MIME ACL.
+
+TK/03 Fix ACL "regex" condition not being available in MIME ACL.
+
+PH/01 Installed a patch from the Sieve maintainer that allows -bf to be used
+ to test Sieve filters that use "vacation".
+
+PH/02 Installed a slightly modified version of Nikos Mavrogiannopoulos' patch
+ that changes the way the GnuTLS parameters are stored in the cache file.
+ The new format can be generated externally. For backward compatibility,
+ if the data in the cache doesn't make sense, Exim assumes it has read an
+ old-format file, and it generates new data and writes a new file. This
+ means that you can't go back to an older release without removing the
+ file.
+
+PH/03 A redirect router that has both "unseen" and "one_time" set does not
+ work if there are any delivery delays because "one_time" forces the
+ parent to be marked "delivered", so its unseen clone is never tried
+ again. For this reason, Exim now forbids the simultaneous setting of
+ these two options.
+
+PH/04 Change 4.11/85 fixed an obscure bug concerned with addresses that are
+ redirected to themselves ("homonym" addresses). Read the long ChangeLog
+ entry if you want to know the details. The fix, however, neglected to
+ consider the case when local delivery batching is involved. The test for
+ "previously delivered" was not happening when checking to see if an
+ address could be batched with a previous (undelivered) one; under
+ certain circumstances this could lead to multiple deliveries to the same
+ address.
+
+PH/05 Renamed the macro SOCKLEN_T as EXIM_SOCKLEN_T because AIX uses SOCKLEN_T
+ in its include files, and this causes problems building Exim.
+
+PH/06 A number of "verify =" ACL conditions have no options (e.g. verify =
+ header_syntax) but Exim was just ignoring anything given after a slash.
+ In particular, this caused confusion with an attempt to use "verify =
+ reverse_host_lookup/defer_ok". An error is now given when options are
+ supplied for verify items that do not have them. (Maybe reverse_host_
+ lookup should have a defer_ok option, but that's a different point.)
+
+PH/07 Increase the size of the buffer for incoming SMTP commands from 512 (as
+ defined by RFC 821) to 2048, because there were problems with some AUTH
+ commands, and RFC 1869 says the size should be increased for extended
+ SMTP commands that take arguments.
+
+PH/08 Added ${dlfunc dynamically loaded function for expansion (code from Tony
+ Finch).
+
+PH/09 Previously, an attempt to use ${perl when it wasn't compiled gave an
+ "unknown" error; now it says that the functionality isn't in the binary.
+
+PH/10 Added a nasty fudge to try to recognize and flatten LDAP passwords in
+ an address' error message when a string expansion fails (syntax or
+ whatever). Otherwise not only does the password appear in the log, it may
+ also be put in a bounce message.
+
+PH/11 Installed exipick version 20050225.0 from John Jetmore.
+
+PH/12 If the last host in a fallback_hosts list was multihomed, only the first
+ of its addresses was ever tried. (Bugzilla bug #2.)
+
+PH/13 If "headers_add" in a transport didn't end in a newline, Exim printed
+ the result incorrectly in the debug output. (It correctly added a newline
+ to what was transported.)
+
+TF/01 Added $received_time.
+
+PH/14 Modified the default configuration to add an acl_smtp_data ACL, with
+ commented out examples of how to interface to a virus scanner and to
+ SpamAssassin. Also added commented examples of av_scanner and
+ spamd_address settings.
+
+PH/15 Further to TK/02 and TK/03 above, tidied up the tables of what conditions
+ and controls are allowed in which ACLs. There were a couple of minor
+ errors. Some of the entries in the conditions table (which is a table of
+ where they are NOT allowed) were getting very unwieldy; rewrote them as a
+ negation of where the condition IS allowed.
+
+PH/16 Installed updated OS/os.c-cygwin from the Cygwin maintainer.
+
+PH/17 The API for radiusclient changed at release 0.4.0. Unfortunately, the
+ header file does not have a version number, so I've had to invent a new
+ value for RADIUS_LIB_TYPE, namely "RADIUSCLIENTNEW" to request the new
+ API. The code is untested by me (my Linux distribution still has 0.3.2 of
+ radiusclient), but it was contributed by a Radius user.
+
+PH/18 Installed Lars Mainka's patch for the support of CRL collections in
+ files or directories, for OpenSSL.
+
+PH/19 When an Exim process that is running as root has to create an Exim log
+ file, it does so in a subprocess that runs as exim:exim so as to get the
+ ownership right at creation (otherwise, other Exim processes might see
+ the file with the wrong ownership). There was no test for failure of this
+ fork() call, which would lead to the process getting stuck as it waited
+ for a non-existent subprocess. Forks do occasionally fail when resources
+ run out. I reviewed all the other calls to fork(); they all seem to check
+ for failure.
+
+PH/20 When checking for unexpected SMTP input at connect time (before writing
+ the banner), Exim was not dealing correctly with a non-positive return
+ from the read() function. If the client had disconnected by this time,
+ the result was a log entry for a synchronization error with an empty
+ string after "input=" when read() returned zero. If read() returned -1
+ (an event I could not check), uninitialized data bytes were printed.
+ There were reports of junk text (parts of files, etc) appearing after
+ "input=".
+
+PH/21 Added acl_not_smtp_mime to allow for MIME scanning for non-SMTP messages.
+
+PH/22 Added support for macro redefinition, and (re)definition in between
+ driver and ACL definitions.
+
+PH/23 The cyrus_sasl authenticator was expanding server_hostname, but then
+ forgetting to use the resulting value; it was using the unexpanded value.
+
+PH/24 The cyrus_sasl authenticator was advertising mechanisms for which it
+ hadn't been configured. The fix is from Juergen Kreileder, who
+ understands it better than I do:
+
+ "Here's what I see happening with three configured cyrus_sasl
+ authenticators configured (plain, login, cram-md5):
+
+ On startup auth_cyrus_sasl_init() gets called for each of these.
+ This means three calls to sasl_listmech() without a specified mech_list.
+ => SASL tests which mechs of all available mechs actually work
+ => three warnings about OTP not working
+ => the returned list contains: plain, login, cram-md5, digest-md5, ...
+
+ With the patch, sasl_listmech() also gets called three times. But now
+ SASL's mech_list option is set to the server_mech specified in the the
+ authenticator. Or in other words, the answer from sasl_listmech()
+ gets limited to just the mech you're testing for (which is different
+ for each call.)
+ => the return list contains just 'plain' or 'login', 'cram-md5' or
+ nothing depending on the value of ob->server_mech.
+
+ I've just tested the patch: Authentication still works fine,
+ unavailable mechs specified in the exim configuration are still
+ caught, and the auth.log warnings about OTP are gone."
+
+PH/25 When debugging is enabled, the contents of the command line are added
+ to the debugging output, even when log_selector=+arguments is not
+ specified.
+
+PH/26 Change scripts/os-type so that when "uname -s" returns just "GNU", the
+ answer is "GNU", and only if the return is "GNU/something" is the answer
+ "Linux".
+
+PH/27 $acl_verify_message is now set immediately after the failure of a
+ verification in an ACL, and so is available in subsequent modifiers. In
+ particular, the message can be preserved by coding like this:
+
+ warn !verify = sender
+ set acl_m0 = $acl_verify_message
+
+ Previously, $acl_verify_message was set only while expanding "message"
+ and "log_message" when a very denied access.
+
+PH/28 Modified OS/os.c-Linux with
+
+ -#ifndef OS_LOAD_AVERAGE
+ +#if !defined(OS_LOAD_AVERAGE) && defined(__linux__)
+
+ to make Exim compile on kfreebsd-gnu. (I'm totally confused about the
+ nomenclature these days.)
+
+PH/29 Installed patch from the Sieve maintainer that adds the options
+ sieve_useraddress and sieve_subaddress to the redirect router.
+
+PH/30 In these circumstances:
+ . Two addresses routed to the same list of hosts;
+ . First host does not offer TLS;
+ . First host accepts first address;
+ . First host gives temporary error to second address;
+ . Second host offers TLS and a TLS session is established;
+ . Second host accepts second address.
+ Exim incorrectly logged both deliveries with the TLS parameters (cipher
+ and peerdn, if requested) that were in fact used only for the second
+ address.
+
+PH/31 When doing a callout as part of verifying an address, Exim was not paying
+ attention to any local part prefix or suffix that was matched by the
+ router that accepted the address. It now behaves in the same way as it
+ does for delivery: the affixes are removed from the local part unless
+ rcpt_include_affixes is set on the transport.
+
+PH/32 Add the sender address, as F=<...>, to the log line when logging a
+ timeout during the DATA phase of an incoming message.
+
+PH/33 Sieve envelope tests were broken for match types other than :is. I have
+ applied a patch sanctioned by the Sieve maintainer.
+
+PH/34 Change 4.50/80 broke Exim in that it could no longer handle cases where
+ the uid or gid is negative. A case of a negative gid caused this to be
+ noticed. The fix allows for either to be negative.
+
+
git://git.exim.org / exim.git / blobdiff