-$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.341 2006/04/19 10:58:21 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.349 2006/04/27 08:53:24 ph10 Exp $
Change log file for Exim from version 4.21
-------------------------------------------
if either of the /etc/hosts.{allow,deny} files is missing). Otherwise, a
451 error is used.
+PH/03 Add -lutil to the default FreeBSD LIBS setting.
+
+PH/04 Change PH/19 for 4.61 was too wide. It should not be applied to host
+ errors. Otherwise a message that provokes a temporary error (when other
+ messages do not) can cause a whole host to time out.
+
+PH/05 Batch deliveries by appendfile and pipe transports did not work when the
+ addresses were routed directly to files or pipes from a redirect router.
+ File deliveries just didn't batch; pipe deliveries might have suffered
+ odd errors.
+
+PH/06 A failure to get a lock for a hints database would erroneously always say
+ "Failed to get write lock", even when it was really a read lock.
+
+PH/07 The appendfile transport was creating MBX lock files with a fixed mode
+ of 0600. This has been changed to use the value of the lockfile_mode
+ option (which defaults to 0600).
+
+PH/08 Applied small patch from the Sieve maintainer.
+
+PH/09 If maildir_quota_directory_regex was set to exclude (say) the .Trash
+ folder from quota calculations, a direct delivery into this folder messed
+ up the contents of the maildirsize file. This was because the regex was
+ used only to exclude .Trash (or whatever) when the size of the mailbox
+ was calculated. There was no check that a delivery was happening into an
+ excluded directory. This bug has been fixed by ignoring all quota
+ processing for deliveries into excluded directories.
+
+PH/10 Added the maildirfolder_create_regex option to appendfile.
+
Exim version 4.61
-----------------
when small messages continue to be delivered. Without this change, the
"time since failure" will always be short, possible causing more frequent
delivery attempts for the huge message than are intended.
+ [Note: This change was subsequently modified - see PH/04 for 4.62.]
PH/20 Added $auth1, $auth2, $auth3 to contain authentication data (as well as
$1, $2, $3) because the numerical variables can be reset during some