doc typo in $load_average

[exim.git] / doc / doc-docbook / spec.xfpt

diff --git a/doc/doc-docbook/spec.xfpt b/doc/doc-docbook/spec.xfpt
index 717e145ab7dfad2a8c3f8e18c357278dd5830616..d04a8fe930f31a5c536799cfe66284ff1b1bdcfe 100644 (file)
--- a/doc/doc-docbook/spec.xfpt
+++ b/doc/doc-docbook/spec.xfpt
@@ -1,4 +1,4 @@
-. $Cambridge: exim/doc/doc-docbook/spec.xfpt,v 1.18 2007/05/15 19:04:56 magnus Exp $
+. $Cambridge: exim/doc/doc-docbook/spec.xfpt,v 1.22 2007/07/20 17:06:15 jetmore Exp $
 .
 . /////////////////////////////////////////////////////////////////////////////
 . This is the primary source of the Exim Manual. It is an xfpt document that is
@@ -10681,7 +10681,7 @@ lookup.
 
 .vitem &$load_average$&
 .vindex "&$load_average$&"
-This variable contains the system load average, multiplied by 1000 to that it
+This variable contains the system load average, multiplied by 1000 so that it
 is an integer. For example, if the load average is 0.21, the value of the
 variable is 210. The value is recomputed every time the variable is referenced.
 
@@ -12949,7 +12949,7 @@ removed at the time the message is received, to avoid any problems that might
 occur when a delivered message is subsequently sent on to some other recipient.
 
 .new
-.option disable_fnync main boolean false
+.option disable_fsync main boolean false
 .cindex "&[fsync()]&, disabling"
 This option is available only if Exim was built with the compile-time option
 ENABLE_DISABLE_FSYNC. When this is not set, a reference to &%disable_fsync%& in
@@ -15327,10 +15327,9 @@ lookups (though Exim does cache lookups).
 
 The &%address_data%& facility is also useful as a means of passing information
 from one router to another, and from a router to a transport. In addition, if
-
 .vindex "&$sender_address_data$&"
 .vindex "&$address_data$&"
-When &$address_data$& is set by a router when verifying a recipient address
+&$address_data$& is set by a router when verifying a recipient address
 from an ACL, it remains available for use in the rest of the ACL statement.
 After verifying a sender, the value is transferred to &$sender_address_data$&.
 
@@ -25171,7 +25170,7 @@ log entry.
 If you want to apply a control unconditionally, you can use it with a
 &%require%& verb. For example:
 .code
-    require  control = no_multiline_response
+    require  control = no_multiline_responses
 .endd
 .endlist
 
@@ -25535,7 +25534,7 @@ only to the current message, not to any subsequent ones that may be received in
 the same SMTP connection. It is provided for debugging purposes and is unlikely
 to be useful in production.
 
-.vitem &*control&~=&~no_multiline_response*&
+.vitem &*control&~=&~no_multiline_responses*&
 .cindex "multiline responses, suppressing"
 This control is permitted for any ACL except the one for non-SMTP messages.
 It seems that there are broken clients in use that cannot handle multiline