Logging: millisecond QT and DT. Bug 2102

[exim.git] / doc / doc-docbook / spec.xfpt

diff --git a/doc/doc-docbook/spec.xfpt b/doc/doc-docbook/spec.xfpt
index a4b1926ecfa3dede4b7755768bb9ebe518de0c35..0d03c2f9c315765d1e989345f22333f709557b0e 100644 (file)
--- a/doc/doc-docbook/spec.xfpt
+++ b/doc/doc-docbook/spec.xfpt
@@ -36118,7 +36118,7 @@ selection marked by asterisks:
 &` incoming_interface         `&  local interface on <= and => lines
 &` incoming_port              `&  remote port on <= lines
 &`*lost_incoming_connection   `&  as it says (includes timeouts)
-&` millisec                   `&  millisecond timestamps
+&` millisec                   `&  millisecond timestamps and QT/DT times
 &` outgoing_interface         `&  local interface on => lines
 &` outgoing_port              `&  add remote port to => lines
 &`*queue_run                  `&  start and end queue runs
@@ -36208,6 +36208,8 @@ process is started because &%queue_only%& is set or &%-odq%& was used.
 .cindex "log" "delivery duration"
 &%deliver_time%&: For each delivery, the amount of real time it has taken to
 perform the actual delivery is logged as DT=<&'time'&>, for example, &`DT=1s`&.
+If millisecond logging is enabled, short times will be shown with greater
+precision, eg. &`DT=0.304`&.
 .next
 .cindex "log" "message size on delivery"
 .cindex "size" "of message"
@@ -36329,6 +36331,8 @@ includes reception time as well as the delivery time for the current address.
 This means that it may be longer than the difference between the arrival and
 delivery log line times, because the arrival log line is not written until the
 message has been successfully received.
+If millisecond logging is enabled, short times will be shown with greater
+precision, eg. &`QT=1.578s`&.
 .next
 &%queue_time_overall%&: The amount of time the message has been in the queue on
 the local host is logged as QT=<&'time'&> on &"Completed"& lines, for