Add sender to log line for DATA timeout.

[exim.git] / doc / doc-txt / ChangeLog

diff --git a/doc/doc-txt/ChangeLog b/doc/doc-txt/ChangeLog
index 8f648575b6c0064d44eff0e06102eeaf6bcdf123..08f59181fdf9b1cd43d7e71479f9ae6182062b41 100644 (file)
--- a/doc/doc-txt/ChangeLog
+++ b/doc/doc-txt/ChangeLog
@@ -1,4 +1,4 @@
-$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.114 2005/04/06 14:03:53 ph10 Exp $
+$Cambridge: exim/doc/doc-txt/ChangeLog,v 1.119 2005/04/06 16:43:59 ph10 Exp $
 
 Change log file for Exim from version 4.21
 -------------------------------------------
@@ -168,6 +168,38 @@ PH/27 $acl_verify_message is now set immediately after the failure of a
       Previously, $acl_verify_message was set only while expanding "message"
       and "log_message" when a very denied access.
 
+PH/28 Modified OS/os.c-Linux with
+
+        -#ifndef OS_LOAD_AVERAGE
+        +#if !defined(OS_LOAD_AVERAGE) && defined(__linux__)
+
+      to make Exim compile on kfreebsd-gnu. (I'm totally confused about the
+      nomenclature these days.)
+
+PH/29 Installed patch from the Sieve maintainer that adds the options
+      sieve_useraddress and sieve_subaddress to the redirect router.
+
+PH/30 In these circumstances:
+        . Two addresses routed to the same list of hosts;
+        . First host does not offer TLS;
+        . First host accepts first address;
+        . First host gives temporary error to second address;
+        . Second host offers TLS and a TLS session is established;
+        . Second host accepts second address.
+      Exim incorrectly logged both deliveries with the TLS parameters (cipher
+      and peerdn, if requested) that were in fact used only for the second
+      address.
+
+PH/31 When doing a callout as part of verifying an address, Exim was not paying
+      attention to any local part prefix or suffix that was matched by the
+      router that accepted the address. It now behaves in the same way as it
+      does for delivery: the affixes are removed from the local part unless
+      rcpt_include_affixes is set on the transport.
+
+PH/32 Add the sender address, as F=<...>, to the log line when logging a
+      timeout during the DATA phase of an incoming message.
+
+
 
 A note about Exim versions 4.44 and 4.50
 ----------------------------------------