X-Git-Url: https://git.exim.org/exim.git/blobdiff_plain/c2fe5cfd1c4ae7b5fcacca7849f4dff5c791fa97..2e3177124893f623c037a44f7972d7d4105da87a:/doc/doc-docbook/spec.xfpt

diff --git a/doc/doc-docbook/spec.xfpt b/doc/doc-docbook/spec.xfpt
index 24d615f14..874c3f0e9 100644
--- a/doc/doc-docbook/spec.xfpt
+++ b/doc/doc-docbook/spec.xfpt
@@ -1,4 +1,4 @@
-. $Cambridge: exim/doc/doc-docbook/spec.xfpt,v 1.41 2008/04/13 11:45:58 tom Exp $
+. $Cambridge: exim/doc/doc-docbook/spec.xfpt,v 1.43 2008/05/14 09:16:38 fanf2 Exp $
 .
 . /////////////////////////////////////////////////////////////////////////////
 . This is the primary source of the Exim Manual. It is an xfpt document that is
@@ -18958,11 +18958,9 @@ filter itself, and the original process that reads the result and delivers it
 are all run in parallel, like a shell pipeline.
 
 The filter can perform any transformations it likes, but of course should take
-care not to break RFC 2822 syntax. A demonstration Perl script is provided in
-&_util/transport-filter.pl_&; this makes a few arbitrary modifications just to
-show the possibilities. Exim does not check the result, except to test for a
-final newline when SMTP is in use. All messages transmitted over SMTP must end
-with a newline, so Exim supplies one if it is missing.
+care not to break RFC 2822 syntax. Exim does not check the result, except to
+test for a final newline when SMTP is in use. All messages transmitted over
+SMTP must end with a newline, so Exim supplies one if it is missing.
 
 .cindex "content scanning" "per user"
 A transport filter can be used to provide content-scanning on a per-user basis
@@ -27554,19 +27552,8 @@ the third string (in this case &"1"&), whether or not the cryptographic and
 timeout checks succeed. The &$prvscheck_result$& variable contains the result
 of the checks (empty for failure, &"1"& for success).
 
-There are two more issues you must consider when implementing prvs-signing.
-Firstly, you need to ensure that prvs-signed addresses are not blocked by your
-ACLs. A prvs-signed address contains a slash character, but the default Exim
-configuration contains this statement in the RCPT ACL:
-.code
-deny    message       = Restricted characters in address
-        domains       = +local_domains
-        local_parts   = ^[.] : ^.*[@%!/|]
-.endd
-This is a conservative rule that blocks local parts that contain slashes. You
-should remove the slash in the last line.
-
-Secondly, you have to ensure that the routers accept prvs-signed addresses and
+There is one more issue you must consider when implementing prvs-signing:
+you have to ensure that the routers accept prvs-signed addresses and
 deliver them correctly. The easiest way to handle this is to use a &(redirect)&
 router to remove the signature with a configuration along these lines:
 .code