">" -> ">=" for EXIM_CLIENT_DH_MIN_BITS+10

[exim.git] / doc / doc-txt / experimental-spec.txt

diff --git a/doc/doc-txt/experimental-spec.txt b/doc/doc-txt/experimental-spec.txt
index 0073b07afccee53f9be7d22ff52ad521b190ca5a..5dd6832b1f6382cc71aa32f4f0736e99d5a161e8 100644 (file)
--- a/doc/doc-txt/experimental-spec.txt
+++ b/doc/doc-txt/experimental-spec.txt
@@ -55,12 +55,13 @@ contents are always valid.  Exim will expand the "tls_ocsp_file" option
 on each connection, so a new file will be handled transparently on the
 next connection.
 
-Exim will check for a validity next update timestamp in the OCSP proof;
+Exim will check for a valid next update timestamp in the OCSP proof;
 if not present, or if the proof has expired, it will be ignored.
 
 At this point in time, we're gathering feedback on use, to determine if
 it's worth adding complexity to the Exim daemon to periodically re-fetch
-OCSP files and somehow handling multiple files.
+OCSP files and somehow handling multiple files.  There is no client support
+for OCSP in Exim, this is feature expected to be used by mail clients.
 
 
 
@@ -520,6 +521,60 @@ EXPERIMENTAL_SRS=yes
 in your Local/Makefile.
 
 
+DCC Support
+--------------------------------------------------------------
+
+*) Building exim
+
+In order to build exim with DCC support add
+
+EXPERIMENTAL_DCC=yes
+
+to your Makefile. (Re-)build/install exim. exim -d should show
+EXPERIMENTAL_DCC under "Support for".
+
+
+*) Configuration
+
+In the main section of exim.cf add at least
+  dccifd_address = /usr/local/dcc/var/dccifd
+or
+  dccifd_address = <ip> <port>
+
+In the DATA ACL you can use the new condition
+        dcc = *
+
+After that "$dcc_header" contains the X-DCC-Header.
+
+Returnvalues are:
+  fail    for overall "R", "G" from dccifd
+  defer   for overall "T" from dccifd
+  accept  for overall "A", "S" from dccifd
+
+dcc = */defer_ok works as for spamd.
+
+The "$dcc_result" variable contains the overall result from DCC
+answer.  There will an X-DCC: header added to the mail.
+
+Usually you'll use
+  defer   !dcc = *
+to greylist with DCC.
+
+If you set, in the main section,
+  dcc_direct_add_header = true
+then the dcc header will be added "in deep" and if the spool
+file was already written it gets removed. This forces Exim to
+write it again if needed.  This helps to get the DCC Header
+through to eg. SpamAssassin.
+
+If you want to pass even more headers in the middle of the
+DATA stage you can set
+  $acl_m_dcc_add_header
+to tell the DCC routines add more information; eg, you might set
+this to some results from ClamAV.  Be careful.  Header syntax is
+not checked and is added "as is".
+
+
 --------------------------------------------------------------
 End of file
 --------------------------------------------------------------