Doc: exim-future@ gone; mention exim-cvs@

[exim.git] / doc / doc-docbook / spec.xfpt

diff --git a/doc/doc-docbook/spec.xfpt b/doc/doc-docbook/spec.xfpt
index 7a3cc8dd614278a08eb8498313a02eef5058021e..d18b09dfed03d25b4d0d9851245f4298e1f82ea3 100644 (file)
--- a/doc/doc-docbook/spec.xfpt
+++ b/doc/doc-docbook/spec.xfpt
@@ -468,10 +468,10 @@ first to check that you are not duplicating a previous entry.
 The following Exim mailing lists exist:
 
 .table2 140pt
+.row &'exim-announce@exim.org'&   "Moderated, low volume announcements list"
 .row &'exim-users@exim.org'&      "General discussion list"
 .row &'exim-dev@exim.org'&        "Discussion of bugs, enhancements, etc."
-.row &'exim-announce@exim.org'&   "Moderated, low volume announcements list"
-.row &'exim-future@exim.org'&     "Discussion of long-term development"
+.row &'exim-cvs@exim.org'&        "Automated commit messages from the VCS"
 .endtable
 
 You can subscribe to these lists, change your existing subscriptions, and view
@@ -14169,6 +14169,10 @@ probably safest to just set it to a little larger than this value.  Eg, with a
 default Exim message size of 50M and a default ClamAV StreamMaxLength of 10M,
 some problems may result.
 
+A value of 0 will disable size limit checking; Exim will still advertise the
+SIZE extension in an EHLO response, but without a limit, so as to permit
+SMTP clients to still indicate the message size along with the MAIL verb.
+
 
 .option move_frozen_messages main boolean false
 .cindex "frozen messages" "moving"
@@ -27345,7 +27349,7 @@ checks.
 
 The &%per_*%& options described above do not make sense in some ACLs. If you
 use a &%per_*%& option in an ACL where it is not normally permitted then the
-update mode defaults to &%readonly%& and you cannot specify the &%strict&% or
+update mode defaults to &%readonly%& and you cannot specify the &%strict%& or
 &%leaky%& modes. In other ACLs the default update mode is &%leaky%& (see the
 next section) so you must specify the &%readonly%& option explicitly.
 
@@ -27399,7 +27403,7 @@ go over the limit is not added to the set, in the same way that the client's
 recorded rate is not updated in the same situation.
 
 When you combine the &%unique=%& and &%readonly%& options, the specific
-%&unique=%& value is ignored, and Exim just retrieves the client's stored
+&%unique=%& value is ignored, and Exim just retrieves the client's stored
 rate.
 
 The &%unique=%& mechanism needs more space in the ratelimit database than the