Implement daemon_startup_{retries,sleep} to control startup retrying.

[exim.git] / doc / doc-misc / WishList

diff --git a/doc/doc-misc/WishList b/doc/doc-misc/WishList
index 93030f270e9cdfaad322a6ac7c5237f453e36dcd..7624940c42aecb7124dc303291130392fcdc4792 100644 (file)
--- a/doc/doc-misc/WishList
+++ b/doc/doc-misc/WishList
@@ -1,4 +1,4 @@
-$Cambridge: exim/doc/doc-misc/WishList,v 1.37 2005/06/07 15:36:47 ph10 Exp $
+$Cambridge: exim/doc/doc-misc/WishList,v 1.40 2005/06/21 14:14:55 ph10 Exp $
 
 EXIM 4 WISH LIST
 ----------------
@@ -1881,12 +1881,6 @@ file would contain the complete email. I suppose there may be other scanning
 solutions with a similar requirement."
 ------------------------------------------------------------------------------
 
-(320) 03-Mar-05 T Options to control daemon retry binding
-
-Currently the daemon tries 10 times at 30-second intervals to listen on an IP
-address. The wish is for options to control these numbers.
-------------------------------------------------------------------------------
-
 (321) 07-Mar-05 S Run an ACL on a sync error
 
 ... and possibly "accept" or "deny" it.
@@ -1985,5 +1979,23 @@ Exim 4 Wish List: 55, 62, 63, 160, 212, 237, 270, 314, 328.
 This is probably a longish-term thing at the moment. Quotas over 2G are now
 supported, but not individual messages; no doubt one day this will be wanted.
 ------------------------------------------------------------------------------
---- HWM 334 ------------------------------------------------------------------
+
+(335) 14-Jun-05 T Re-arrange default configuration
+
+A small niggle which might be worth fixing is the ordering of the ACL in the
+default configuration file. The relay_from_hosts and authenticated clauses
+would be better off before the dnslists examples. However, this should be left
+until a x.x0 release, because of the documentation implications.
+------------------------------------------------------------------------------
+
+(336) 16-Jun-05 M Show recipient(s) after header check failure
+
+The mainlog line for "There is no valid sender in any header line" shows the
+sending host and the envelope sender, but does not show any recipients. There
+has been a request to show recipients. Presumably this should be on some new
+log selector, and it must have a cutoff maximum number of recipients. NOTE: the
+data in the reject log does show the envelope recipients as part of its
+additional data.
+------------------------------------------------------------------------------
+--- HWM 336 ------------------------------------------------------------------
 ---------------------------- End of WishList ---------------------------------